Google search engine
Home News Airline News FAA to Announce Cause of Nationwide Ground Stop That Canceled 12,000 US...

FAA to Announce Cause of Nationwide Ground Stop That Canceled 12,000 US Flights

FAA Set to Reveal Cause of Nationwide Ground Stop Today
Image: U.S. Navy Air Traffic Controller by U.S. Forest Service (source) via rawpixel, cc0

More than 12,000 flights were canceled and departures blocked nationwide for over four hours on November 13, 2026, when the Federal Aviation Administration (FAA) issued its third-ever nationwide ground stop. The disruption affected over 1 million passengers across the United States and led to more than 20,000 total cancellations over the weekend following the event.

FTI Network Flooded by Excessive Connection Attempts

The FAA Telecommunications Infrastructure (FTI) network experienced over 1,000 connection attempts every 4 to 5 seconds during the outage, which caused instability in aircraft communications and radar data feeds. This affected 17 of the FAA’s 22 Air Route Traffic Control Centers, responsible for managing en-route

traffic nationwide, along with several Terminal Radar Approach Control facilities.

Investigators identified excessive data flooding originating from two key locations: a radar site in Amarillo, Texas, and a radio communications site in El Dorado, Arkansas. At El Dorado, L3Harris was in the process of installing a new Juniper Networks router to replace a 25-year-old Cisco router when the event occurred. A similar router had recently been installed at the Amarillo site.

Contractor-Performed Upgrades Lacked FAA Technician Oversight

The router installation was carried out by L3Harris technicians without direct involvement or oversight from FAA employees. The Professional Aviation Safety Specialists (PASS) union, which represents FAA technicians, stated

that no FAA technicians were involved in the upgrades leading to the ground stop. Traditionally, FAA employees conduct risk assessments and coordinate maintenance with contractors, but this protocol was not followed here.

A PASS representative noted uncertainty regarding the qualifications of personnel supervising the work, questioning whether those present held the certifications and experience required for such critical systems. A CNN report cited FAA technicians as having escorted L3Harris contractors into the El Dorado facility but not actively supervising the router replacement process.

FAA to Announce Root Cause Next Week

FAA Administrator Bryan Bedford told reporters on November 19, 2026, that investigators are “very close” to confirming

the root cause of the November 13 ground stop. Transportation Secretary Sean Duffy is scheduled to announce the official findings during a news conference on November 20, 2026.

Following the incident, the FAA halted further installation of Juniper Networks routers and reactivated older Cisco equipment at the impacted sites. Bedford acknowledged that the agency had underestimated the range of impact from the affected router, describing a misjudgment between the physical location of the router and its central position in the national airspace system communications network.

Union Raises Concerns on Modernization Oversight

The PASS union emphasized that historically contractors performed work only under FAA risk assessments and

coordination. It expressed concern over the lack of qualified FAA personnel during the upgrades that triggered the outage. The union representative questioned standards for defining who qualifies to supervise critical network modifications.

FAA modernization efforts to replace aging infrastructure, including routers over 25 years old, rely heavily on contractor work, increasing the need for strict risk management. Past incidents involving L3Harris include a 2009 network outage caused by a misconfiguration, which also led to widespread flight delays and cancellations.